The Solidworks Simulation You May and May Not Know

Tuesday, September 21, 5:30pm - 7:30pm (EDT)

Time shown in-05:00 America, New York

Are you concerned about the reliability of your products? How do you know if you have the optimum design?

About this event
Most companies validate designs today based on these criteria:

Intuition and Experience
Based on Previous Design
Over Design

Then we build a physical prototype, break it and redesign, repeating this cycle until you get it right. Sound familiar?

There is a better way. With SolidWorks Simulation and High End Abaqus tools we can simulate virtually - running many more iterations in a much shorter period of time - getting our products to market faster.

Join us at Groundswell Startups on Tuesday, September 21st from 5:30-7:30pm as TriMech Application Engineer, Stephen Choi, will be reviewing the capabilities of SolidWorks Simulation tools. SOLIDWORKS guru, Dana Parish, will be discussing some new higher-end SImulation tools including Non Linear, Dynamic Explicit Solvers, CFD and ElectroMagnetics.

Networking & Pizza will begin at 5:30. Seminar begins at 6:00.

Please fill out the information below to register for the event.

Going
Interested
Can't go

Full name

Email address

You're going to "The Solidworks Simulation You May and May Not Know".

We've sent a confirmation email to your email address. Be sure to check your junk folder in case you haven't received the confirmation.

Add to Calendar 2021/09/21 17:30:00 2021/09/21 19:30:00 America/New_York The Solidworks Simulation You May and May Not Know Are you concerned about the reliability of your products? How do you know if you have the optimum design?

About this event
Most companies validate designs today based on these criteria:

Intuition and Experience
Based on Previous Design
Over Design

Then we build a physical prototype, break it and redesign, repeating this cycle until you get it right. Sound familiar?

There is a better way. With SolidWorks Simulation and High End Abaqus tools we can simulate virtually - running many more iterations in a much shorter period of time - getting our products to market faster.

Join us at Groundswell Startups on Tuesday, September 21st from 5:30-7:30pm as TriMech Application Engineer, Stephen Choi, will be reviewing the capabilities of SolidWorks Simulation tools. SOLIDWORKS guru, Dana Parish, will be discussing some new higher-end SImulation tools including Non Linear, Dynamic Explicit Solvers, CFD and ElectroMagnetics.

Networking & Pizza will begin at 5:30. Seminar begins at 6:00. 2412 Irwin Street Melbourne, FL 32901 false MM/DD/YYYY 30 OPAQUE abkFVElNdzAInKZvGmwm85011

You're interested in "The Solidworks Simulation You May and May Not Know".

We've sent a confirmation email to your email address. Be sure to check your junk folder in case you haven't received the confirmation.

Thank you!

Your changes have been saved. Thanks for keeping us updated.

2412 Irwin Street Melbourne, FL 32901

Jarin Eisenberg, jarin@swellstartups.com

Link: